Cole Harris
The shower repairs Melbourne and the other plumbing equipment can at times require a lot of work. Fortunately, however, shower repair projects are not always difficult or lengthy. In fact, many repair jobs on your shower can be done quickly using tools that you probably already have around the house. This is true if your fibreglass shower or tub gets damaged. A fibreglass shower can be repaired with an easy to use kit. These are sold at most hardware stores that carry plumbing supplies. Before you rush out and purchase a kit, though, you need to be absolutely sure that your shower is made of fibreglass. Some tubs can be made of other materials, such as cast iron, and they cannot be fixed in the same way.
Let us understand the common problems of non-functional showers
- Why Shower Faucets Leak
When you have a shower head that is dripping, it is because the shower faucet has a problem. Sometimes the shower faucets can get blocked by deposits from water or parts of the shower faucet may be rusty. It may also be that the seals found within the shower faucet are worn out. The gaskets or rubber rings that are found between the metal parts which move are prone to wearing down and when this happens, water begins to drip. When you have a dripping shower, make sure not to tighten the valve handle too much as this can damage it thus increasing your shower repair costs.
- Faucet
One of the common causes of shower repairs is a shower faucet or valve that leaks. You can end up losing plenty of water from a leaking shower faucet. It gets worse if the leak is from the side that brings in hot water. This is because the water heater will warm more water than is required due to the leak resulting in a loss of energy. The water can also get into the wall causing it to rot and this will cost you since the repairs may end up being very expensive.
- Repair Work
When conducting shower repairs, a plumber will normally lay rags on the floor of the shower or the bathtub before doing any work. This is important in order to avoid any parts of the faucet falling down the drain. A valve that shuts off the water supply to the shower is then turned off, and it is normally located in the bathroom or in the basement. The method used to make the shower repairs will depend on the type of faucet that is in use.
- Compression Valve
A compression valve or faucet is one which has two valve knobs, whereby one brings in cold water and the other one is for hot water supply. The washers and rubber seals present in compression valves normally wear out causing water to come through the movable parts. A compression valve can be repaired by disbanding the faucet and replacing the faulty washers and rubber seals. The plumber needs a faucet washer kit which has all the parts required for repair work.
- Delta Shower Valve
If the shower repairs involve a Delta shower faucet that is leaking, the handle has to be removed to expose the cartridge. The plumber then removes the cartridge and cleans the faucet area with a rag to remove any deposits. A new cartridge is firmly put in place and the handle is placed back in its proper position. Other types of shower faucets including the Moen shower valve and the Pfister shower valve also require a replacement of the cartridge.
CONCLUSION
A shower repairs Melbourne might seem like a project that a do-it-yourselfer can manage well, but it really can get quite complex. Depending on where the leak is originating, a tiled shower wall could need to come out. That’s actually pretty in-depth, and it is not recommended to attempt it without hiring a professional plumber. A plumber is therefore required to have the skills to install and repair such appliances including carrying out shower repairs.
